Sr clutch problem

[Barnacles240]

my car is acting up, my pedal sags down a little and i have to pull it up with my foot, where it sits it engages the slave cylinder about a centimeter, but when i boost the RPM's shoot up then it pulls, its very annoying, anyone have a clue how to fix it?

[DEPPY]

Try bleeding the clutch see if that helps

[Cash]

I had the same problem, and I tried bleeding the clutch several times but it didn't help. So I was gonna replace the slave cylinder and then one day I pulled the clutch pedal up and it stayed up and I haven't had problems with it sense. ...so strange.

[DEPPY]

It may be your clutch master isn't working correctly either if bleeding it doesn't help.

[Lone_Wolf]

my guess is slave or master cyl

[J Squared]

Have you taken out the clutch dampening box by the slave cylinder? That will cause a mushy pedal. Also, try adjusting the pedal throw, the adjuster is high up on the pedal assembly, opposite the firewall from the master cylinder. The rod for the MS threads into the pedal assembly, and you can screw it in and out to set the pedal engagement.

[slammed95240sx]

yeah i would take out the clutch dampening box. then try and adjust the pedal throw. if that doesnt work i suggest buying a new master.
mine was like that but i put a whole new system in it and now it works great

[shawn shawn]

dampening box needs to be in the trash!

[de3zy]

same shit happening to my car! haha can anyone tell me what's the worst that could happen when you DIY taking out the dampening box?

[~The_Duke~]

Try bleeding the lines first though...

[hellfire]

You can't bleed the lines properly without taking out that box. So no, take out the box, then bleed the lines.

Nothing bad can happen really.. Disconnect one end, reconnect it to the slave's rubber line.

Bleed. Done.

Tyler

[Barnacles240]

my clutch was gone!

[de3zy]

took me a while but i did it too. take out the damp box, changed MC + SC, bleed, works fine now